CATALOG 1. FOREWORD. 2. SYSTEM FEATURES. 3. SYSTEM TYPE. 4. INTRODUCTION 5. STACKING AND RACK-MOUNTING RECEIVERS. 3) 6. SINGLE CHANNEL RECEIVER FEATURES. 7. DUAL CHANNEL RECEIVER FEATURES. een 8 8. HAND-HELD TRANSMITTER FUNCTION & FEATURES... 9. BODY-PACK TRANSMITTER FUNCTION & FEATURES. vine 8 10. SYSTEM CONNECTION... inns as 7 11. TRANSMITTER CONNECTION. 12. RECEIVER OPERATING INSTRUCTION... neon ino 9 13. TRANSMITTER OPERATING INSTRUCTION... enn 8 14. SPECIFICATION SYSTEM COMPOSITION 1. Receiver. 2.
INTRODUCTION Hand-held transmitter{compose the handheld microphone system) Body-pack transmitter(compose the Cavalier microphone/Guitarist microphone/Headset microphone system) Single channel antenna diversity receiver. Dual channel antenna diversity receiver. STACKING AND RACK-MOUNTING RECEIVERS ] (@3C SINGLE CHANNEL RECEIVER FEATURES 1. Power Button: Tums the receiver ON/OFF. 2.
DUAL CHANNEL RECEIVER FEATURES 1. Power Button: Tums the receiver ON/OFF. 2. Power On Indicator: This light glows when the receiver is plugged into and electrical outlet and switch is pushed, it indicates that the receiver is on. 3. Channel A B Volume Control: Rotate the knob to increase or decrease the volume of the receiver output. 4. Channel A B Down Function Button: Sets channel data. 5. Channel A B Up Function Button: Sets channel data 6. Channel A.
1. Antenna. 2. LCD Information Display: Show the transmitter power/frequency channel ect. 3.Up Function Button: Sets channel data. 4. Down Function Button: Sets channel data. 5. Power / Mute Button: Power ON/OFF transmitter. 6. Battery Cover: Open the cover and set Alkaline batteries, or NI-MG rechargeable batteries. 7. Antenna Connector. 8. Input Connector: It is TA4 PINS connector; It is suitable for the lavaliere microphone system/ Headset microphone systems/ Guitarist microphone system.
RECEIVER OPERATION INSTRUCTION (CHANNEL DATA SETTING) 1. Tum on the receiver. Length press Length press 7% Dotcom] [e=% (est ze) of 2. Channel Set Up: Press Up and Down bunion to select the channel data. af Go" Fob (Mummify) of 2.1 Length press "MANY" to enter channel setting mode, the figure is flashing, during three seconds after operation is finished. the system will lock and save the message and then exit. 2.
Resolver Output Connector: High Z Audio Low Z Audio” Output Configuration: { Overbalance} Actual Impedance: 3kG 8000 * Output Level: Microphone Liveliness Levelheaded Receiver Audio Output Level (25 KHz deviation, 400Hz tone) XLR connector (into 600 ohm load): 24mV 1/4 inch connector {into 3000 ohm load): 360mV Impedance: Body Pack (input): 500kQ (GT) Receiver : 50 tums antenna level; 3000 ohm at mic level Modulation: FM; 1:25KHz RF Power Output: 10 mW Dynamic Range: >100 dB RF Sensitivity: -105dBm (S/N -12
