User's Manual

WR400& 4 Front& rear panel function/ instruction
3
Front Panel
1. Front Antenna Hole A: Move the receiving antenna to front panel.
2. Front Antenna Hole B: Move the receiving antenna to front panel.
3. Power Switch: Power ON/OFF the receiver.
4. Squelch Adjusting Knob: Adjust the squelch sensitivity of receiver to strengthen
the signal quality or system receiving distance. This knob is factory pre-set,
normally no further adjustment is required.
5. Volume Adjusting knob: Adjust the volume output of receiver.
6. Antenna Diversity Signal Indicators:indicate the receiver signal is from
antenna “A”or“B”.
HT400 Transmitter Function/Instruction
1. Grille: Protects the cartridge and help reducing the breath sounds and wind
noise.
2. Battery Cover: Open it to install the battery.
3. Battery Cover Lock: lock or unlock the battery cover.
4. Low Battery Indicator: Red light glows when it is lack of power and should
renew the battery.
5. Power Switch: Power ON/OFF the transmitter.
6.Gain Adjustment: Adjust the transmitter audio input gain in high, middle
or Low levels
PT400 Transmitter Function/Instruction
4
1. Power Switch: Power ON/OFF the transmitter.
2. Antenna: Transmit the RF signal of transmitter.
3. Belt Clip: Gird the transmitter to the belt or guitar strap.
4. Audio Input Jack: It is TAF 3 pins connector, it is suitable for lavalier system/
Headset system/guitar and instrument system.
5. Low Battery Indicator: Red light glows when it is lack of power and should
Renew the battery.
6. State Setting Switch: Set the using state to lavalier system/headset system/
guitar system.
7. Gain Adjustment: Adjust the transmitter audio input gain.
(1)
(2)
(7) (3)
(4) (5)(8)
(6)
(7)
(6)
(7)
(6)
(7)
(6)
(4) (5)(8) (4) (5)(8) (4) (5)(8)
Rear Panel
(10)(11)(12) (12) (1 3 )(14) (12) (12) (9)
(1)
(4)
(5)
(3)
(2)
ON
OFF
AA AA
L M H
(6)
(5)(4)
(1)
(3)
(2)
1. 5V
1. 5V
L G
H
(6) (7)
7. AF Peak Indicator: Indicate the receiver audio signal strength.
8. Power Indicator: Indicate the receiver power state.
9. Antenna“A”( TNC) : Receiverd the RF signal from transmitter.
10. Antenna“B”( TNC) : Receiverd the RF signal from transmitter.
11. 1/ 4' Phone Jack Audio Output Connector( Unbalanced impedance) :
An unbalanced audio cable with 1/ 4' phone jack can be connected to
the input of amplifier/ audio mixer.
12.XLR Audio Output Connector(Balanced Output): A balanced audio cable
with XLR plug can be connected to the input of amplifier/ audio mixer.
13.Power Switch For Each Receiving Module:Power on the receiving modules
separately.
14.Power Jack:Connect the Power AC/DC adapter to receiver.