Operating instructions

M215 Installation and Operation

Enphase Microinverter Installation

Follow the instructions in this section to install Enphase M215™ Microinverters.

WARNING: Be aware that only qualified personnel should connect the Enphase Microinverter

to the electricity network.

WARNING: Be aware that installation of this equipment includes risk of electric shock. Normally

earthed conductors may be unearthed and energised when an earth fault is indicated.

Compatibility and Capacity

The Enphase M215 Microinverters are electrically compatible with most 60-cell PV modules. For more

information, see Technical Data on page 24 of this manual.

WARNING: The M215 may be paired only with a 60-cell PV module.

Refer to the Enphase website (http://www.enphase.com/support/downloads

) for a list of electrically compatible

PV modules and approved mounting rail systems. To ensure mechanical compatibility, be sure to order the

correct connector type for both microinverter and PV module from your distributor.

Electrical Compatibility

Model Number

Works with PV Module Type

PV Module Connector Type

M215-60-230-S22

60 cell

MC-4 Type 2 Locking

Capacity

Maximum number of M215s per 20 amp AC Branch Circuit

Service type

Max M215s per AC branch circuit

230V single-phase

400V three-phase