Technical data
Table Of Contents
- Important Information
- The Enphase Envoy Communications Gateway
- Installation Planning and Preparation
- Install the Envoy
- 1. Find the Envoy Serial Number
- /2. Register the Envoy
- 3. Find a Location for the Envoy
- 4. Connect to the Internet
- 5. Check the Internet Connection
- 6. Install the Modules and Microinverters
- 7. Check the Envoy’s Progress
- 8. Wall Mount the Envoy (Optional)
- 9. Build the Virtual Array
- 10. View System Performance in Enlighten
- Envoy Operation
- Troubleshooting
- Power Line Communication Troubleshooting
- Network Basics and Troubleshooting
- Issue: IP Address Problems
- Issue: LCD Screen Displays “-Web”
- Issue: LCD Screen Displays “Envoy Failure +Web or -Web”
- Issue: LCD Screen Displays "Scanning Inhibited"
- Issue: The Envoy has Good Signal Strength but is Too Far from the Router
- Issue: Wireless Adapter Wi-Fi Problems
- Issue: How Set Up Wi-Fi Without Wi-Fi WPS
- Issue: Internet Traffic is Slower After Installing a Bridge
- DHCP versus Static IP Addressing
- MAC Filtering
- Firewall Settings
- Replacing an Envoy
- Envoy Local Interface
- Technical Data
Envoy Installation and Operation
2014 Enphase Energy Inc. 141-00011 Rev 05
44
9. Enter the Envoy serial number.
10. Enter the authorization number from the Envoy Interface.
11. Click Get Token.
12. Copy the token.
13. Paste or enter the token in the Grid Profile screen.
14. Click Apply Grid Profile.
This propagates the settings to the microinverters.
Copy this token.