Technical data
Table Of Contents
- Important Information
- The Enphase Envoy Communications Gateway
- Installation Planning and Preparation
- Install the Envoy
- 1. Find the Envoy Serial Number
- /2. Register the Envoy
- 3. Find a Location for the Envoy
- 4. Connect to the Internet
- 5. Check the Internet Connection
- 6. Install the Modules and Microinverters
- 7. Check the Envoy’s Progress
- 8. Wall Mount the Envoy (Optional)
- 9. Build the Virtual Array
- 10. View System Performance in Enlighten
- Envoy Operation
- Troubleshooting
- Power Line Communication Troubleshooting
- Network Basics and Troubleshooting
- Issue: IP Address Problems
- Issue: LCD Screen Displays “-Web”
- Issue: LCD Screen Displays “Envoy Failure +Web or -Web”
- Issue: LCD Screen Displays "Scanning Inhibited"
- Issue: The Envoy has Good Signal Strength but is Too Far from the Router
- Issue: Wireless Adapter Wi-Fi Problems
- Issue: How Set Up Wi-Fi Without Wi-Fi WPS
- Issue: Internet Traffic is Slower After Installing a Bridge
- DHCP versus Static IP Addressing
- MAC Filtering
- Firewall Settings
- Replacing an Envoy
- Envoy Local Interface
- Technical Data
Envoy Installation and Operation
2014 Enphase Energy Inc. 141-00011 Rev 05
17
9. Build the Virtual Array
When the system is energized and the Envoy detects at least one microinverter, create the virtual array in
Enlighten from the installation map you created.
You can scan and upload the paper copy of the Installation Map, or you can use the ArrayGun feature from
the Enphase Installer Toolkit to easily
build and configure a system. Refer to
http://enphase.com/products/arraygun/ for
more information.
To build the virtual array manually:
a. Log in to Enlighten.
b. Use Array Builder to create the
virtual array in Enlighten.
c. Use your installation map as your
reference.
To see the Array Builder demo, go to
http://enphase.com/support/videos.
Once the virtual array is built, Enlighten
displays a graphic representation of the
PV system. It also shows detailed current
and historical performance information.
10. View System Performance in Enlighten
Once the array is built and the system is activated, you can log in to Enlighten to view site data.
a. If you have not done so already, log in to Enlighten to view system data.
b. Refer to “How the Envoy Works with Enlighten” on page 28 for more information.