Technical data

Page 11 Copyright Enphase Energy Inc. 2009 141-00008 REV 06
Install the Envoy Cable Connections
To install the Envoy, perform the steps below while referring to the installation
diagram below.
1. Register the Envoy as soon as possible. Call Enphase Customer Support at
877-797-4743 or visit https://enlighten.enphaseenergy.com/register and
register the Envoy by its serial number.
2. Remove the Envoy removable serial number label as shown in the diagram
below and attach it to the microinverter installation map.
3. Plug the AC power cord into the AC input on the Envoy, and then plug the
other end of the power cord into an ordinary 120VAC power outlet (not a
power strip) located somewhere near your broadband router.
Reminder: Do not plug the Envoy into a power strip, surge protector,
or uninterruptable power supply (UPS). The Envoy contains the
protective circuits required for long, reliable operation. The surge
suppression or filtering components of a power strip or other
protective device can substantially diminish communication
performance.