Technical data

Envoy Installation and Operation

Change or View the Grid Profile

Many Enphase Microinverters have field adjustable voltage and frequency trip points. Trip points are input

voltage or frequency values that trigger the microinverters to shut down when the values are exceeded. If

local regulations require adjustments to these trip points, the installer can set up the system to use an

alternate Grid Profile (set of trip points).

NOTE: Only an authorised installer, following the requirements of the local regulatory

authority, is allowed to make Grid Profile adjustments.

NOTE: Grid profile changes are applied only after a microinverter is detected.

In some regions and in some situations, microinverter trip points must be adjusted to account for high grid

voltage or for local conditions. Grid profile management tasks include:

 Adjust system trip points for frequency and voltage if required by local utilities

 Reset trip points to default values

 View or verify current grid profile

 Generate a report for confirmation of site settings to the utility or other authority

To change a grid profile, you need a “Change Token”. Change tokens are issued on a per Envoy serial

number basis. Contact Enphase Customer Support for your Grid Profile Change Token as directed on

the screen.

1. From the System Overview screen, click on Inventory and verify that all installed

microinverters are detected.

2. Click Administration to access the Administration menu.

The default log in credentials for the Administration menu are:

 Username: admin

 Password: admin

The System Administration screen appears.

Click to select Device

Grid Configuration