Technical data

Envoy Installation and Operation
Copyright  2012 Enphase Energy 141-00014 Rev 03
20
LCD Screen Display at Initial Start Up
When the Envoy is started up for the first time, it goes
through the initial boot sequence. During this initial
boot sequence, the Envoy LCD screen display
progresses as shown:
Initial Communications Check
The last two screens in the initial sequence alternate
until the Communications Check ends, after 20
minutes. The Envoy normally displays
"-Web" for two to three minutes after the first start up.
It then sends the first report to Enlighten. When
Enlighten responds, the Envoy displays “+Web”.
Subsequent Start Up
After a power outage or Envoy shut down, the Envoy is
ready to work just five minutes after reapplying power.
You will know the Envoy has completed booting and has
started normal operation when it displays both an IP
address and the “+Web” status indication in the LCD
screen. The normal, post installation boot sequence is
similar to the initial start up, although the “Initializing Data”
screen is not repeated.
[e] Enphase Energy
Booting [||||||]
Starting R3.2.0
2012/06/06 16:21:20
169.254.120.1 -Web
2407W 783kWh 25

Communications check
Searching Devices
192.168.2.140 +Web
2407W 783kWh 25
Level: [ ]
Devices: 25
Initializing Data
2012/06/06 16:21:20
{LANGUAGE SELECTION}