Technical data

Envoy Installation and Operation

9. Configure the Grid Profile

The following steps describe how to configure the grid profile. After all of the microinverters at the site are

detected, you can apply the grid profile.

Each Grid Profile contains a set of trip points. Trip points are input voltage or frequency values that

trigger the microinverters to shut down. These trip points vary from region to region.

If you need to change the grid profile subsequent to this initial procedure, follow the steps in “Change or

View the Grid Profile” on page 36

NOTE: Enphase Microinverters will not begin exporting power until the Envoy Communications

Gateway is installed and has detected all of the microinverters at the site. In addition, the grid

profile must be configured and the Envoy must have propagated these settings to the

microinverters.

a. Open the Internet browser application on a computer that is connected to the same local

network as the Envoy.

b. In the browser address window, enter the IP address shown in the LCD screen of the Envoy.

Once the browser has successfully connected with the Envoy, the System Overview screen is displayed

in the browser window.

c. From the Language menu, select your preferred language.

d. Click on Inventory and verify that all installed microinverters are detected.

e. Click Administration to access the Administration menu.

The default log in credentials for the Administration menu are:

Username: admin

Password: admin

Click to

select

Language

Click to access

the

Administration

menu.