Technical data

Envoy Installation and Operation

5. Connect Power Line Communication Bridges (Optional)

If the Envoy needs to be located away from the router, at a distance where an Ethernet cable is not

practical, use power line communication bridges or purchase a wireless Ethernet bridge. Bridges allow

the Envoy to communicate with the broadband router without the need for additional Ethernet cabling. To

install the bridges:

WARNING! Do not remove power from the Envoy if the LCD displays:

“Upgrading. . . Do Not Unplug.”

a. Plug one of the bridges into the same AC outlet that the Envoy is using.

b. Connect one end of the Ethernet cable

to the Ethernet port on the Envoy.

c. Connect the other end of that Ethernet

cable to the bridge.

d. Plug the other bridge into an AC outlet

near the broadband router.

e. Connect one end of a second Ethernet

cable to the second bridge.

f. Connect the other end of the Ethernet

cable to the broadband router.

g. Reapply power to the Envoy to force it

to refresh its IP address.

6. Select Language

After the Envoy starts up it will request that

you set the Language.

 The Envoy LCD panel will scroll

through the available language

settings, and will continue to scroll until

you make a selection. When you see

the setting you need, press the Menu button

and hold it down for two seconds.

English

Français

Deutsch

Italiano