Technical data

Envoy Installation and Operation

Install the Envoy

To install the Envoy, perform the following steps while referring to the diagram shown.

BEST PRACTICE: When powered up and connected for the first time, the Envoy may

retrieve an automatic upgrade from Enphase. Because this upgrade may take up to 45

minutes, connect the Envoy first at the site (connect to both AC power and the

broadband router) so that it performs the upgrade well before the solar module

installation is complete.

1. Add Serial Number Label to Map

a. Remove the Envoy removable serial number label as shown in the diagram.

b. Attach the serial number label to the microinverter installation map or make note of it for

registration in the next step.