Technical data

Envoy Installation and Operation

Envoy Local Interface

Connection to the Enphase Enlighten web-based monitoring and analysis software requires an Internet

connection. However, if there is no Internet access at the installation site, it is still possible to

communicate directly with the Envoy using the Ethernet port and a personal computer with a web

browser. The following steps describe how to access the Envoy data through the local connection.

1. Connect one end of the Ethernet cable supplied with the Envoy to the Ethernet port on

the Envoy.

2. Connect the other end of the Ethernet cable to the Ethernet port of the computer.

3. Open the Internet browser application on the computer.

4. In the browser address window, enter the IP address displayed in the LCD screen of

the Envoy.

NOTE: If you fail to make a connection at this point, you can manually configure your

subnet to 169.254.120.2 and subnet mask to 255.255.0.0. If this does not correct the

problem, contact Enphase Customer Support.

Once the browser has successfully connected with the Envoy, the home screen is displayed in the

browser window.

Home Screen

The home screen provides a system overview and shows the current status of the microinverters that

have been identified by this Envoy. From this screen, you can access other screens in the interface.