Technical data

Envoy Installation and Operation

e. Assess the power line communications. To do this:

• Wait until the Priority New Device Scan is complete (The message Priority Scan is

Active will no longer be shown on the LCD).

• Press and hold the Envoy menu button. Release it when the LCD window displays

Enable Communication Check. The check will run for 20 minutes.

• Note the number of bars shown in the Communication Check. If fewer than three

bars are shown, see “Power Line Communication Troubleshooting” on page 24.

f. Refer to “LCD Screen Displays” on page 13 for more information.

7. Wall Mount the Envoy (Optional)

NOTE: Before mounting the Envoy, it is best to perform a Communication Check as

described on page

17 to optimize the location of your Envoy.

After you have positioned your Envoy for optimal communications and it is has begun to detect

devices, you can mount the Envoy on a wall. To do this:

a. Select a cool, dry, indoor location for the Envoy.

b. Use two drywall screws or wall anchors (not included) to affix the Envoy to the wall,

mounted at the dimensions shown. You will need two #8 (4.17 mm or 0.16 in.

diameter); maximum screw head diameter is 8.9mm (0.35 in.).

c. Slide the Envoy onto the mounting screws, aligning the Envoy screw holes with the

screws installed in step b.