User Manual

Planning for a Three-Phase IQ Microinverter System – North America

Q Cable and raw Q Cable must be supported at intervals not to exceed 6 feet, ensuring the cable does not

touch the roof surface.

Manufacturer

Model

Image

Nine Fasteners

DCS-1307 PV cable clip

DCS-1306 USE-2 cable clip

Burndy / Wiley Electronics

ACME ACC-PV PV cable clip

Heyco Products

SunRunner PV cable clip

Supporting the DC Module Leads

Prepare the modules using clips on the DC module leads to prevent the leads from resting on the roof. It is

best to prepare the modules on the ground before installation. Install the wire clips and DC module leads to

allow for easy connection to the microinverter while also supporting the conductors off the roof.

Once the modules are prepared, install them on the racking. Secure any loose wires or cables to the module

frames with properly sized wire clips. Ensure that all conductors are supported off the roof.