Cut Sheet

Install the Communications Adapter
The kit includes the wireless USB adapter, with USB cable (for power and communications) and tie wraps. To install the adapter adjacent to an
Enphase IQ Envoy or in an Enphase IQ Combiner, do the following:
A ) If installing in an IQ Combiner, open the enclosure door.
B ) Select or locate the installation position for the adapter:
• For IQ Combiner 1.75 (Model X-IQ-AM1-240-B), place the adapter on the front side of the deadfront near the bottom.
• For IQ Combiner 3 and IQ Combiner 3C (Models X-IQ-AM1-240-3 and Model X-IQ-AM1-240-3C), place the adapter on the front side of the
deadfront on the right side (see image below).
• For the IQ Combiner+ (Model X-IQ-AM1-240-2), place the adapter on the front side of the deadfront on the left side.
• For IQ Envoy (Model ENV-IQ-AM1-240), select a mounting location near the IQ Envoy, so that the USB cable can reach between the IQ
Envoy and the adapter.
C ) Plug the free end of the USB cable into a USB port on the IQ Envoy.
D ) If installing in an IQ Combiner, use the tie wraps and/or adhesive
patch to hold the adapter in place in the designated location. Either
weave the tie wraps through the openings in the dead front, or use
the adhesive patch to hold the adapter in place. You can use both, if
needed.
E ) If installing the adapter with an IQ Envoy not housed in an Enphase
Combiner, you can use screws to mount the adapter to the wall or a
board. Use one screw in each of the two recesses of the adapter.
2
INSTALLATION
Preparation
A ) Check that the IQ Envoy or IQ Combiner is de-energized.
B ) Be sure to wear anti-static protection, such as a properly grounded anti-static wrist strap.
1
DANGER! Risk of electric shock. Always de-energize the IQ Envoy or IQ Combiner before beginning the following procedure.
3
Upgrade the IQ Envoy Software
You must upgrade the IQ Envoy software to work with the COM-
MS-KIT-01 and other Ensemble components.
A) Use the Enphase Installer Toolkit app on your smart phone to up-
grade the IQ Envoy with Envoy embedded software version 6.0.x.
B) Follow the instructions as shown in the Installer Toolkit app to
complete the installation.
Plastic
deadfront (the
deadfront on your
combiner may
be transparent or
opaque).
Cable ties