Enphase Microinverter Manual
Table Of Contents
- Important Safety Information
- The Enphase IQ System
- Planning for Microinverter Installation
- Parts and Tools Required
- Enphase Microinverter Installation
- Step 1: Position the Enphase Q Cable
- Step 2: Position the Enphase Q Aggregator or Junction Box
- Step 3: Mount the Microinverters
- Step 4: Create an Installation Map
- Step 5: Manage the Cabling
- Step 6: Connect the Microinverters
- Step 7: Terminate the Unused End of the Cable
- Step 8: Complete Installation of the Enphase Q Aggregator or Junction Box
- Step 9: Connect the PV Modules
- Step 10: Energize the System
- Set Up and Activate Monitoring
- Troubleshooting
- Technical Data
IQ 7 / IQ 7+ / IQ 7X / IQ 7A with EN4 Bulkhead Installation and Operation
© 2020 Enphase Energy Inc. All rights reserved. 141-00047-01
30
Enphase Q Cable Accessories
The Enphase Q Cable is available with several accessory options for ease of installation, including:
• Field wireable connectors (male): (Q-CONN-10M) Make connections from any Field Wireable
female connector
• Field wireable connectors (female): (Q-CONN-10F) Make connections from any Q Cable open
connector or Field Wireable male connector
• Enphase Q Aggregator: (Q-BA-3-1P-60) Aggregates up to three fully populated 20A branch
circuits and supports solar arrays of up to 11.5kWac with a single rooftop aggregator
• Enphase raw Q Cable: (Q-12-RAW-200) 300 meters of 12 AWG cable with no connectors
• Cable clips: (Q-CLIP-100) Used to fasten cabling to the racking or to secure looped cabling
• Disconnect tool: (Q-DISC-10) Disconnect tool for Q Cable connectors, DC connectors, and AC
module mount
• Q Cable sealing caps (female): (Q-SEAL-10) One needed to cover each unused connector on
the cabling
• Terminator: (Q-TERM-10) Terminator cap for cut cable ends