Envoy IQ Installation
Table Of Contents
- Enphase IQ Envoy
- Contact Information
- FCC Compliance
- Other Information
- This Class B digital apparatus complies with Industry Canada ICES-003.
- For third-party license information, refer to enphase.com/licenses.
- For Enphase patent information, refer to enphase.com/company/patents/.
- For warranty text, refer to enphase.com/warranty.
- Copyright © 2017 Enphase Energy Inc. All rights reserved.
- Audience
- Table of Contents
- SAFETY
- The Enphase IQ Envoy
- Installation Planning and Preparation
- Review the following pre-installation checks before you install the IQ Envoy.
- To install the production CT
- Installing the IQ Envoy – Part 1
- Installing the IQ Envoy – Part 2
- Use one of the following methods to detect devices (Enphase Microinverters and/or Enphase Batteries).
- IQ Envoy Operation
- You can track system installation progress with the Enphase Installer Toolkit mobile app.
- Connecting to IQ Envoy
- Once your mobile device and the Envoy are on the same LAN, you can connect to the IQ Envoy.
- Refer to enphase.com/installer-toolkit/ for more information on the Enphase Installer Toolkit.
- Select Diagnostic Tools to ping the Envoy, check network connectivity, and check the network route.
- Troubleshooting
- The following sections describe possible problems and solutions.
- Troubleshoot power line communication issues as follows.
- This means that communications from other Envoy(s) have been detected. To prevent this issue:
- Check for the following conditions.
- If Enphase Customer Support authorizes an IQ Envoy replacement (RMA), perform the following steps.
- Technical Data
IQ Envoy Installation and Operation
© 2017 Enphase Energy Inc. 141-00039 Rev 01
40
•
•
The app then indicates that a clear message was sent.
Clear GFI Tripped Condition
---
-
-
There are two ways to send a clear message to the microinverter. Note that the condition will not clear after
sensor reset if the cause of the failure is still present.
Method 1: Clear this error through Enlighten
•
•
•
•
•
•
A GFI sensor reset task was issued on 08/03/2015 01:34 PM CDT for this