Envoy IQ Installation
Table Of Contents
- Enphase IQ Envoy
- Contact Information
- FCC Compliance
- Other Information
- This Class B digital apparatus complies with Industry Canada ICES-003.
- For third-party license information, refer to enphase.com/licenses.
- For Enphase patent information, refer to enphase.com/company/patents/.
- For warranty text, refer to enphase.com/warranty.
- Copyright © 2017 Enphase Energy Inc. All rights reserved.
- Audience
- Table of Contents
- SAFETY
- The Enphase IQ Envoy
- Installation Planning and Preparation
- Review the following pre-installation checks before you install the IQ Envoy.
- To install the production CT
- Installing the IQ Envoy – Part 1
- Installing the IQ Envoy – Part 2
- Use one of the following methods to detect devices (Enphase Microinverters and/or Enphase Batteries).
- IQ Envoy Operation
- You can track system installation progress with the Enphase Installer Toolkit mobile app.
- Connecting to IQ Envoy
- Once your mobile device and the Envoy are on the same LAN, you can connect to the IQ Envoy.
- Refer to enphase.com/installer-toolkit/ for more information on the Enphase Installer Toolkit.
- Select Diagnostic Tools to ping the Envoy, check network connectivity, and check the network route.
- Troubleshooting
- The following sections describe possible problems and solutions.
- Troubleshoot power line communication issues as follows.
- This means that communications from other Envoy(s) have been detected. To prevent this issue:
- Check for the following conditions.
- If Enphase Customer Support authorizes an IQ Envoy replacement (RMA), perform the following steps.
- Technical Data
IQ Envoy Installation and Operation
© 2017 Enphase Energy Inc. 141-00039 Rev 01
31
View or Change Wi-Fi Settings
When the Envoy uses Wi-Fi to connect with Enlighten, select > to
view Wi-Fi configuration information. From here you view
Available Networks (WPS and AP), Update Country, Enable AP
Mode, and view Device information.
If you replace the broadband router at the installation site, you
need to update the connection information on the IQ Envoy. To
do this:
•
•
If you need to disconnect the Envoy from a Wi-Fi network:
•
•