Envoy IQ Installation
Table Of Contents
- Enphase IQ Envoy
- Contact Information
- FCC Compliance
- Other Information
- This Class B digital apparatus complies with Industry Canada ICES-003.
- For third-party license information, refer to enphase.com/licenses.
- For Enphase patent information, refer to enphase.com/company/patents/.
- For warranty text, refer to enphase.com/warranty.
- Copyright © 2017 Enphase Energy Inc. All rights reserved.
- Audience
- Table of Contents
- SAFETY
- The Enphase IQ Envoy
- Installation Planning and Preparation
- Review the following pre-installation checks before you install the IQ Envoy.
- To install the production CT
- Installing the IQ Envoy – Part 1
- Installing the IQ Envoy – Part 2
- Use one of the following methods to detect devices (Enphase Microinverters and/or Enphase Batteries).
- IQ Envoy Operation
- You can track system installation progress with the Enphase Installer Toolkit mobile app.
- Connecting to IQ Envoy
- Once your mobile device and the Envoy are on the same LAN, you can connect to the IQ Envoy.
- Refer to enphase.com/installer-toolkit/ for more information on the Enphase Installer Toolkit.
- Select Diagnostic Tools to ping the Envoy, check network connectivity, and check the network route.
- Troubleshooting
- The following sections describe possible problems and solutions.
- Troubleshoot power line communication issues as follows.
- This means that communications from other Envoy(s) have been detected. To prevent this issue:
- Check for the following conditions.
- If Enphase Customer Support authorizes an IQ Envoy replacement (RMA), perform the following steps.
- Technical Data
IQ Envoy Installation and Operation
© 2017 Enphase Energy Inc. 141-00039 Rev 01
17
Installing the IQ Envoy Part 2
You must complete installation Part 2 after installing the PV system.
5. Detect the Devices
Use one of the following methods to detect devices (Enphase Microinverters and/or Enphase Batteries).
Method A: Provision Devices with Installer Toolkit
Use the Installer Toolkit mobile app to configure the IQ Envoy with the serial numbers of the installed
devices.
-
-
The Device Communications LED lights solid green when all of the
provisioned devices are communicating or solid amber if any devices
are not communicating.
Method B: Discover Devices with Installer Toolkit
Use the Installer Toolkit mobile app to set the number of devices the IQ
Envoy should search for on the power line.
-
The Device Communications LED flashes green while scanning. It lights solid green when all of the
devices you installed are communicating or solid amber if any devices are not communicating.
Connecting to IQ Envoy with
a Mobile Device:
Point) Wi-Fi network allows
you to connect your mobile
device to the IQ Envoy. The
AP Mode LED lights solid
green when the network is
available.
•
•
-