User's Manual

USER MANUAL 1.34

STM 300 / STM 300C / STM 300U

 STM 300C FCC ID:SZV-STM300C IC:5713A-STM300C

 TCM 320C FCC ID:SZV-TCM320C IC:5713A-TCM320C

STM 300U: (902.875 MHz)

 PTM 210U FCC ID:SZV-PTM210U IC:5713A-PTM210U

 STM 300U FCC ID:SZV-STM300U IC:5713A-STM300U

 TCM 300U FCC ID:SZV-STM300U IC:5713A-STM300U

 TCM 310U FCC ID:SZV-STM300U IC:5713A-STM300U

 TCM 320U FCC ID:SZV-TCM320U IC:5713A-TCM320U

OEM Requirements

In order to use EnOcean’s FCC ID number, the OEM must ensure that the following condi-

tions are met:

 End users of products, which contain the module, must not have the ability to alter the

firmware that governs the operation of the module. The agency grant is valid only when

the module is incorporated into a final product by OEM integrators.

 The end-user must not be provided with instructions to remove, adjust or install the

module.

 The Original Equipment Manufacturer (OEM) must ensure that FCC labeling require-

ments are met. This includes a clearly visible label on the outside of the final product.

Attaching a label to a removable portion of the final product, such as a battery cover, is

not permitted. The label must include the following text:

STM 300C:

Contains FCC ID: SZV-STM300C

The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (i.) this device may not cause harmful interference and

(ii.) this device must accept any interference received, including interference that

may cause undesired operation.

STM 300U:

Contains FCC ID: SZV-STM300U

The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (i.) this device may not cause harmful interference and

(ii.) this device must accept any interference received, including interference that

may cause undesired operation.

When the device is so small or for such use that it is not practicable to place the state-

ment above on it, the information required by this paragraph shall be placed in a promi-

nent location in the instruction manual or pamphlet supplied to the user or, alternative-

ly, shall be placed on the container in which the device is marketed. However, the FCC

identifier or the unique identifier, as appropriate, must be displayed on the device.