User's Manual

USER MANUAL
© 2013 EnOcean | www.enocean.com TCM 300x / TCM 320x User Manual | Page 51/54
TCM 300 / TCM 300C / TCM 300U
TCM 320 / TCM 320C / TCM 320U
RD_BASEID
Bit 7 Bit 0
When this command is sent to the TCM, the base ID range num-
ber is retrieved though an INF_BASEID telegram.
INF_BASEID
Bit 7 Bit 0
This message informs the user about the ID range base number.
BaseIDByte3 is the most significant byte.
SET_RX_SENSITIVITY
Bit 7 Bit 0
This command is used to set the TCM radio sensitivity.
In LOW radio sensitivity, signals from remote transmitters are
not detected by the TCM receiver. This feature is useful when
only information from transmitters in the vicinity should be proc-
essed. An OK confirmation telegram is generated after TCM sen-
sitivity has been changed.
Sensitivity=0x00 Low sensitivity
Sensitivity=0x01 High sensitivity
0xA5
0x5A
0xAB
0x58
X
X
X
X
X
X
X
X
X
ChkSum
0xA5
0x5A
0x8B
0x98
BaseIDByte3
BaseIDByte2
BaseIDByte1
BaseIDByte0
X
X
X
X
X
ChkSum
0xA5
0x5A
0xAB
0x08
Sensitivity
X
X
X
X
X
X
X
X
ChkSum