User's Manual
Table Of Contents
- 1 General description
- 2 Functional description
- 3 Radio telegram format
- 4 PTM 535 configuration
- 5 Application information
- 6 Regulatory information
- 7 Product history
USER MANUAL
PTM 535 / PTM 535U / PTM 535J – ENOCEAN TRANSMITTER MODULE
© 2019 EnOcean | www.enocean.com F-710-017, V1.0 PTM 535 / 535J User Manual | v1.5 | September 2020 | Page 17/33
4.2 PTM 535 configuration interface
The PTM 535 configuration interface consists of test points MP1- MP6. The function of these
test points is summarized in Table 2 below.
Table 2 – PTM 535 configuration interface
4.3 PTM 535 test point location
Figure 8 below shows the location of the test points MP1 … MP6. For the exact location
refer to the product drawing in chapter 1.6.
Figure 8 – PTM 535 test point location
Pad
Signal
Name
Characteristics
Segger
J-Link Signal
Segger
J-Link Pin
MP1
VCC
Configuration interface
(Supply voltage)
VTref
1
MP2
GND
Configuration interface
(Ground)
GND
4/6/8/10
/12
MP3
TDIO
Configuration interface
(Data)
TMS
7
MP4
TCK
Configuration interface
(Clock)
TCK
9
MP5
V+
Power supply (from Segger)
5V-Supply
19
MP6
RESET
Optional
RESET
15