User's Manual

Troubleshooting
Page 2
Page 3
Page 4
Cautionary Suggestions
• Installation and maintenance must be performed by a
qualified electrician.
• Installations and maintenance must be performed in
accordance with state, local, and national electrical
codes and requirements.
Figure 5: Mounting Sequence
Problem Solution
LEDs do not flash
when a is button
pressed
The energy in the battery may
have drained. Check, and if
needed, replace the battery
(see Figure 4)
Buttons do not
easily move
when pressed
Return unit for replacement
Figure 4: Opening the WS2’s case to access the battery
Step
Description
1 Separate, if needed, the cover and back
plates.
2 Remove the plastic pull tab from the WS2 to
allow the battery to come in contact with the
terminals. (See figure 2)
3 Press each button and verify that both the
green and red LEDs flash and that the button
moves smoothly. (See figure 3)
4 If the LEDs do not flash when a button is
pressed, then check, and if needed, replace
the battery. The battery is accessed after
opening the case as shown in figure 4.
5 Position the WS2 on either the wall or on a
junction box with the LEDs on the top and the
Enlighted logo on the bottom. (See Figure 5)
6 Use the provided tapping screws (or machine
screws for a junction box) to attach the WS2
to the wall.
7 Align the back plate (with the arrow pointing
up) to the WS2. Affix the back plate to the
WS2 by firmly tightening both captive screws.
8 Snap on the cover plate with the arrow (on its
back side) pointing up.
9 Save usage card for room occupants.
Installation Steps
Both Wall and Junction Box Mounting
Figure 2: Remove plastic
tab to allow battery to
power unit
Figure 3: Press each
button to verify operation
and that LEDs flash