User's Manual

Page 2
Page 3
Page 4
Installation
Figure 7
The Ruggedized sensor is shipped with the cable attached to the
sensor. Figure 1.
Figure 1
Figure 6
LED Status Description/Solution
LED not on Check power and wiring
Purple solid All LEDs are on during boot time for 5-6
seconds
Green blinking Sensor commissioned and working
Red blinking Incompatibility between LED driver and sensor
– Replace LED driver and if not resolved,
replace sensor.
Red solid Faulty sensor – replace sensor
Green solid Sensor installed, initialized, and
uncommissioned – waiting for discovery.
Blue solid Image being upgraded.
LED Description
Caution
Installation and maintenance must be performed by a qualified
electrician in accordance with local, state, and national electrical
codes (NEC) and requirements.
Step 1: Turn off all power to the light fixture by switching off
the circuit breaker.
Step 2: Mount the Control Unit (CU) in a UL approved
enclosure. Refer to the Control Unit Installation Guide. See
Figure 7 for detailed wiring connections from the CU.
Step 3: Remove the cover plate of the
½ inch LB conduit body by removing
the two screws. Figure 2.
Figure 2
Step 4: Thread the Ruggedized
sensor onto LB conduit body.
Figure 3.
Figure 4
Step 6: Knock out a ½ inch hole on the end of the light
fixture. Using the ½ inch chase nipple, connect the LB
conduit to the fixture. See Figure 5.
Step 5: Replace the cover and two
screws on the LB conduit body.
Figure 4.
Figure 3
Figure 5
Chase Nipple
Step 7: Pull the Ruggedized sensor cable through the chase
nipple into the fixture and connect it to the Control Unit.
See Figure 6. For wiring connections to the CU, see Figure 7.
Step 8: If the ruggedized senor cable is not long enough to
reach the Control Unit, use an RJ12 coupling to connect
the rugged sensor cable to an Enlighted 7ft Sensor cable.
(CBL-2-7F)
Step 9: Switch on the circuit breaker to turn the power on.
Enlighted
Control Unit
Enlighted
Control Unit