Instruction Manual

Page 2 Page 3 Page 4
Installation
Figure 5
Caution
Installation and maintenance must be performed by a qualified
electrician in accordance with local, state, and national electrical
codes (NEC) and requirements.
Figure 1
LED Status Description/Solution
LED not on Check power and wiring
Purple solid All LEDs are on during boot time for 5-6
seconds
Green blinking Sensor commissioned and working
Red blinking Incompatibility between LED driver and sensor
– Replace LED driver and if not resolved,
replace sensor.
Red solid Faulty sensor – replace sensor
Green solid Sensor installed, initialized, and
uncommissioned – waiting for discovery.
Blue solid Image being upgraded.
LED Description
Step 1: Turn off all power to the light fixture by switching off
the circuit breaker.
Step 2: Mount the Control Unit (CU) in a UL approved
enclosure. Refer to the Control Unit Installation Guide. See
Figure 5 for the wiring connections from the CU.
Step 3: Determine the
location of the sensor in
the fixture. Figure 1.
The Smart Sensor (SU-4S)
should be mounted to
the ceiling within a few
inches (between 1
3/4
” to
3”) of the lighting fixture
and over the service
area of the light.
Step 4: Select a place for
the RJ12 data cable
from the CU to exit and
make a small cut in the
ceiling tile for the cable
to exit.
Step 5: Install the Smart Sensor
anchor screw (as shown).
Figure 3.
Step 6: Connect the RJ12
data cable to the Sensor
(bottom entry). Figure 3.
Step 7: Slide the Smart Sensor onto the screw head.
Step 8: Slip the excess RJ12 data cable up into the plenum
area and adjust the ceiling tile to the original position.
Figure 4.
Step 9: Switch on the circuit breaker to turn the power on.
Figure 2
Figure 3
Figure 4
Anchor Screw
RJ12 Cable
1”
Drill 5/8”
hole