Users Manual Part 1

18
Getting started with the mobile app Tikee Remote
Update your Tikee
Before using the Tikee, check that its firmware version is the latest online (see page 14).
If this is not the case, update your Tikee either:
- From the microSD card.
Go to our website https://enlaps.io/en/download, download the update according to your
camera model from a computer following the instructions given, copy it on the microSD card
previously formatted (see formatting chapter). You can also download the update from the
myTikee cloud platform.
Note : The file must be named exactly «TikeeUpdate.fw». Be careful, some browsers may rename
the file when downloading the same file successively.
1
Camera off - Insert the microSD card into the dedicated slot.
2 Turn on your Tikee and and from the mobile app, go to :
The update may take a few minutes. Once finished, you will receive a notification on the mobile
application and then it will disconnect.
If the Tikee is charging, it will restart automatically (the Power LED will go out and then start
flashing before becoming steady again).
If the Tikee is not charging, it will switch off. You can then simply restart it by pressing the power
button .
Once the update is complete, you can reconnect to the Tikee Remote mobile application. The
update file is automatically deleted from the microSD card once it is done.
- Directly from the cloud via the Tikee Remote mobile application
This method requires a valid Wi-Fi or 4G/LTE connection and a microSD card into the slot SD.
Stand close to your Tikee and launch the update from the cloud. The update is done following
the steps displayed on the screen.
Caution/Important : In both cases, it is recommended to connect your Tikee to a USB plug
because the update is only done if the battery level is higher than 50%
Note : On some smartphones, after an update, switch to the airplane mode 30 seconds before
reconnecting to the mobile application.
From SD
From cloud
Software update
From cloud