Users Manual Part 1

14
Getting started with the mobile app Tikee Remote
3. You access directly to the status screen of your Tikee
The Tikee has 2 possible status:
- STOP : basic status of the Tikee, in inactive mode the camera will not take a photo
sequence and will switch off after 30 minutes of inactivity. You will have to access the camera
and press the power button to start it again
- START : this mode allows the Tikee to remain on and therefore to take into account
the sequences set up ( see page 19). If no sequence is in progress or programmed, the device
connects to the cloud at least every 24 hours to retrieve new information (for example, adding a
new sequence from myTikee).
To switch between the two status, press « START » or « STOP » on the mobile app.
Warning : If the Tikee turns off while it was on STOP, you will need to access the camera and
press the power button to turn it back on.
Setting up the connection of your Tikee to myTikee cloud platform
If you want use your Tikee’s WiFi modem or 4G LTE modem to regularly upload photos to myTikee
cloud platform, you have to complete the following settings.
Active connectivity mode is displayed on the mobile application screen (None, Wifi or LTE)
Select the desired connection mode (wifi or LTE) and set up the connection, save and test it.
Please contact your operator for connecion settings.
Available space on the
memory card
Note: it should remain at least 200MB
of free space to start a sequence
Firmware release of Tikee
Tikee’s name
/ serial number
To disconnect from Tikee
Tikee’s status
Remaining battery
percentage
None Wifi LTE
Prévisualisation
!