Specifications

13
12
Chapter 4 using amigo
Chapter 4 using amigo
Using the Freeze Function
FREEZE allows you to take a
temporary picture of an image.
This enables you to move the
unit to better view the desired
object.
1. Hold or place the unit over
desired location.
2. Press and hold the “FREEZE” button for 2 seconds.
(see Figure 1) to freeze the image
3. You may freely adjust the image size and color
viewing mode as desired after freezing the image.
(Refer to page 10 for more details)
4. Press the “FREEZE” button
a second time to exit.
Tilting the LCD Display
The LCD screen is designed
to tilt up 90 degrees.
Depending on the user’s
position, tilting the screen can
sometimes make viewing
images easier and clearer. (see
Figure 2)
Note: Do not force the LCD beyond the angle of 90
degrees or you will cause damage the unit.
Figure 1
Figure 2
90° max.
Tightening the LCD Hinge
Depending on the user’s
preference, the LCD hinge can
be tightened or loosened. To
tighten the hinge, turn the
Phillips screws clockwise
located on the front of the unit.
To loosen the hinge, turn the Phillips screws counter
clockwise. DO NOT OVER TIGHTEN.
Writing with Amigo
1. Place the writing stand over the desired material.
The tallest portion of the stand should face you.
2. Turn the Amigo ON. Gently set the Amigo into the
stand with Power Button facing you. Tilt the LCD
toward you.
3. Make sure the viewing mode is set to either Color
or Black & White mode. Reduce the magnification
to the lowest level.
4. Place your pen under stand and write on the
material.