Specifications

Remote Access: Accessing a PLC via PC Remote Access
64 VisiLogic: Getting Started
Remote Access
Remote Access: Accessing a PLC via PC
Use VisiLogic to activate access a remote Vision controller and:
Download and upload projects
Remotely operate the controller's HMI through your PC
Run On-Line Test mode on the remote controller
Run Information Mode.
You can access:
Stand-alone controllers that are directly connected to the PC via a cable.
Controllers within a CANbus or TCP/IP network
Either stand-alone or networked controllers via GSM or landline modem.
Note
•
In addition to using VisiLogic to access a remote Vision, Unitronics
provides a stand-alone utility called Remote Access. This utility can
also access Unitronics M90/91 and Jazz controllers. It may be freely
downloaded from http://www.unitronics.com.
Accessing a PLC via VisiLogic
Before you can access a controller, you must establish a communication link:
Direct Connection: PC-Controller
1. Connect your PC to any controller using the programming cable supplied
with the controller kit.
In the case of the V1040, the USB cable may be used; note that COM port
1 function is suspended when this port is physically connected to a PC