Specifications

Controller Settings Communication and OS-Controller Menu
VisiLogic: Getting Started 59
Communication and OS-Controller Menu
Via this menu, you can
Set PC communication parameters (non-modem) to enable PC-PLC
communication.
Reset and initialize a PLC, enter Stop and Run modes, get RTC values as
well as reset the RTC.
Get COM Parameters and PLC status.
Install an Operating System (O/S) in a PLC
Check Network Status
Run, Reset, Initialize
When you click one of the buttons shown in the figure below, your PC will
access the controller selected in
Communicate with OPLC.
Set RTC
These are the values of your PC's clock. Click Set RTC to import these
values into the RTC of the controller.
Get Vision
RTC Current
Values
Click to view the current PLC settings
Run
Click to run the current program in the PLC.
Stop
Click to stop the current PLC program.
Reset
Click to reset the PLC, and reinstall any values preset in the program, such
as Timers.
Reset &
Initialize
Click to reset, reinstall any preset values, and initialize all memory
operands