Specifications

Getting Started Information Mode
VisiLogic: Getting Started 31
mode.
• Reset the controller. This restarts your program;
restoring power-up values to all data types except
for those protected by the battery backup. The
battery protects Real Time Clock (RTC), all
operand, and Data Table values.
• Initialize the controller. This restarts your program
and initializes all values, restoring 0 values to all
data types.
Time & Date
• View the Real Time Clock (RTC) settings. Note
that the RTC settings control all time-based
functions.
• Change the RTC settings via the controller’s
keyboard.
Unit ID The Unit ID number identifies a networked controller. You
can:
• Change the ID number. The new ID number will
remain in effect until the controller is reset.
• Burn the ID number into the controller’s FLASH
memory. This is a permanent change.
Serial Port 1
Serial Port 2
• View and edit communication settings.
•
Select to Change or Burn the new settings.
Ethernet
(Enhanced Vision,
if an Ethernet card
is installed)
Enables you to view and edit IP address, Socket settings,
and other TCP/IP settings.
Monitor
Communications
(Enhanced only)
This is a built-in communications 'sniffer'
• Touch screen models: select Serial or Ethernet,
then press Monitor. Note the button that allows
you to toggle between Hex and ASCII
• Non-touch screen models: Select Communication,
then select Serial or Ethernet> COM Buffer. Use
F2 to toggle between Hex and ASCII. In addition,
press Enter, and then the Down key to toggle
between. Tx and Rx.
CANbus
• Built-in CANbus communications 'sniffer'
•
Change the CANbus baud rate.
Touchscreen
(Touchscreen
models only)
Enables you to calibrate the touchscreen, if it is not
responding accurately to screen taps.
SD Card
(Enhanced
Division)
Removable
memory storage
Enables you to upload and download VisiLogic
applications, OS firmware, and Data Table data from/to an
SD card.
You can use these features to 'clone' a PLC application.
Function Reserved for