Specifications

21
Chapter 5 Charging & using batteries
To charge the Nickel-Metal Hydride (NiMH) batteries
inside your Pebble, simply connect the included *AC
adaptor/power supply as described on the bottom of
page 10. You can continue to use the Pebble even
while the batteries are being charged.
Your Pebble has two small
indicator lights (LEDs)
located on the side of the unit.
The LEDs indicate the current
power state and charge status
of the batteries (see Figure 1).
Refer to the table below for more information
regarding the meaning of each LED indicator light:
Battery Charging Procedure
Built-In Battery Charger Status Indicators
#2
#1
Figure 1
LED #1
Color
LED #2
Color
Meaning:
Green Off Battery OK & DC Present
Green Amber Battery charge near completion
Green Red Batteries charging
Off Off Battery or DC power only
Amber Off Faulty Battery charge
Note: When your Pebble batteries are getting low, Pebble
will begin to sound a series of audible short beeps. The
beeping rate will speed up every minute to a rate of once
every 3 seconds. When this occurs, please recharge or
replace the batteries immediately.
*The user assumes full responsibility for charging batteries
in any other charger different than Pebble’s built-in charger.