Specifications

1. No Power to Merlin VGA

• PressthePowerbuttonontheMerlinVGA’s.Alightnexttothe

Power button should turn illuminate, indicating the power is on.

• MakesurethepowersupplycordfortheMerlinVGAis  

completely plugged into the AC outlet.

• Makesurethepowersupplycordiscompletelypluggedintothe

power input jack on the lower bottom of the Merlin VGA.

• Checkthepowerstrip/surgeprotector’son/offswitchandcircuit

breaker if the Merlin VGA is plugged into one.

• ChecktomakesureyourVGAmonitorisproperlyconnected 

(both VGA signal and power) as detailed on page 10.

2. Blurry or Out-of-Focus Image

• Cleantheprotectiveglasscoveringthecamerawiththenon- 

abrasive lens cleaning cloth provided with your Merlin VGA.

• Cleanyourmonitorscreenwithanon-abrasiveclothsprayed 

with a glass cleaning solution.

• TurntheMerlinVGAlightswitchONorOFFasneededto  

compensate for any glare or shadows caused by the ambient

room lighting. The switch is located immediately underneath

your Merlin VGA on the left hand side (see item #7, pages 8/9).

• TrychangingthedefaultfocussettingfromAutoFocusmodeto

 IntelligentFocusLockmode(see page 18). Depending on your

specific application, either mode may help to improve focus.

3. Merlin VGA Lights are Not "ON"

•CheckthatMerlinhaspower.Ifnot,seeitem1,above

•Checkthatthelightswitch(item #7, pages 8/9) under Merlin

 LCD’scontrolpanelisswitchedtotheONposition.

Troubleshooting