Specifications

24
25
settinG up with your ComputersettinG up with your Computer
Figure 1
Figure 2
NOTE: Be sure to complete the initial
set-up on page 10 prior to following
the instructions below.
1. Connect the Foot Switch Pedal cable
into the jack labeled “Foot Switch”
on the back of Merlin LCD/Plus
(see Figure 2).
2. Connect the female end of the VGA
extension cable into the port labeled
“COMPUTER” on the back of your
Merlin LCD/Plus (see Figure 2).
3. Connect the male end of the VGA
Extension Cable into the VGA port
of your computer. This is usually
where you would connect your VGA
monitor to your computer
(see Figure 3).
Figure 3
The Merlin Plus permits computer
connectivity using the included VGA
extension cable (Plus version only). The
included Feature Kit (Plus version only)
allows adjustment of the window size and
position of the computer's image,
magnified camera-based images, or split-
screen mode (Plus version only). The
included footswitch (Plus version only)
allows you to toggle between each mode
for hands-free operation (Figure 1).


Figure 4
4. To attach the Feature Kit Control
Box, connect the loose end of the
Feature Kit Control Box coiled cord to
the “Control Box” input on the rear of
the Merlin LCD/Plus as shown. Do not
use extreme force when making this
connection, as the end connector will
only fit in one direction (see Figure 4).
Please note: The optional Feature Kit Control Box (sold
separately) can be used with a standard Merlin LCD (non-Plus
version) to provide line markers and windowing functions. When
used along with the Merlin LCD Plus, the control box also provides
control of "Split-Screen" viewing modes.
