User manual
9
8
important saFety preCautions
• This product contains moving
parts. Please use caution when
moving the adjustable slide arm or
when transporting the DaVinci to
avoid possible injury to hands and
fingers.
• To avoid personal injury or damage
to the DaVinci, do not make any
other type of connections to the
input jacks.
Susceptibility to Interference
There may be temporary degradation of the image when the DaVinci is
subjected to a strong radio frequency field, electro-static discharge or
transient electrical noise. An electro-static discharge (caused by static
electricity) may cause the screen to go blank. If this happens, disconnect
the AC power from the electrical outlet, wait 30 seconds, and connect the
AC power again.
Compliance Warnings
• Electromagnetic compatibility: The use of accessories and cables other
than those specified by Enhanced Vision may result in increased
emissions or decreased immunity of the DaVinci.
• Placement of equipment: The DaVinci should not be used adjacent to or
stacked with other equipment.
DaVinCi setup
1. Unpacking and transporting the DaVinci.
During unpacking and transporting, be sure to lift
the DaVinci by the built-in carrying handle. Do not
attempt to lift or carry the LCD by the base or the
camera arm. (See Figure 1)
2. Setup the DaVinci. Place the DaVinci on a flat,
level surface such as a table or desk.
3. Connect the AC power. Connect the attached
power cord to the power supply. (See Figure 2)
Connect the power cord to an available electrical
outlet. (See Figure 3) To offer additional protection
during an electrical storm, a surge protector may
also be used and is recommended. Connect the
other end of the power supply to the DaVinci
where it is labeled “+19VDC”
4. Turn the power on. On the front, right side
of the DaVinci, press and release the power
button. (See Figure 4).
*Pressing the Power button for less than 5
seconds will put the device in Standby.
**Pressing it again will wake the DaVinci up
from Standby
***Pressing the Find and Power Button will
reset the DaVinci
*** To turn the DaVinci off, press and hold the
Power Button for more than 5 seconds or until
“EV DaVinci” appears on the screen.
Figure 1
Figure 2
Figure 3
DAVINCI SETUP
Figure 4