User manual

21
20
Adjusting the Brightness
1. Press the “Mode” and “Find” button located on the Front Panel or
Control Console of the DaVinci to enter the Menu.
2. The “Brightness” should already be highlighted. Press the “Find”
button to select the brightness adjustment option.
3. Turn the zoom wheel clockwise to brighten the display or
counterclockwise to dim the display.
4. Once the desired brightness is set, press the “Mode” button to exit
or wait 10 seconds for the Menu to exit.
Adjusting the White Balance
The color white is often affected by the lighting used in a room. The
DaVinci White Balance selection allows you to achieve optimum clarity.
1. Press the “Mode” and “Find” button located on the Front Panel or
Control Console of the DaVinci to enter the Menu.
2. Turn the zoom wheel clockwise until “System Configuration” is
highlighted.
3. Press the “Find” button to select the “System Configuration”
sub menu.
4. Choose between Auto, Normal, Warm, or Cold by highlighting the
desired White Balance.
“Color: Auto” – Automatically adjusts to the lighting in the room
“Color: Normal” – Casts a balanced tone
“Color: Warm” – Casts a red tone
“Color: Cold” – Casts a blue tone
5. Press the “Find” button to select the desired setting.
6. Press the “Mode” button to exit the menu.
aDjusting brightness & white balanCe
Using Line Markers, Windowing, & Column Markers
Line Markers and Windowing
Line Markers can be used as a reading guide by providing horizontal
lines across the screen.
Windowing can be used as a reading guide by only displaying a
portion of the screen.
Turning Markers On/Off:
Pressing the “Marker” on the Control Console will allow you to toggle
through the Marker Options
*Column Marker is only available when Control Console is plugged in.
Off • Column Marker • Line Marker • Windowing
Adjusting Line Markers and Windowing
(Column Marker Cannot be adjusted):
To adjust the position of the Marker:
1. Press the “Mode” and “Find” button located on the Front Panel or
Control Console of the DaVinci to enter the Menu.
2. Turn the zoom wheel until “Marker Position” is selected. Then press
the “Find” button to select.
3. When this option is selected it will be highlighted RED. When this
occurs, you can turn the zoom wheel clockwise/counterclockwise to
move the Line Markers or Visible area up/down.
using & aDjusting markers
Press and hold the Marker button while turning
the Zoom Wheel clockwise/counter-clockwise.
Control Console Shortcut: