User manual

3.3 Quick install
It is easy to use “Quick install” function to create a volume. Depend on how
many physical disks or how many residual spaces on created VGs are free, the
system will calculate maximum spaces on RAID levels 0/1/3/5/6. “Quick install”
function will occupy all residual VG space for one UDV, and it has no space for
snapshot. If snapshot function is needed, please create volumes by manual, and
refer to section 4.4 for more detail.
Step 1: Select “Quick install” then choose the RAID level to set. Please refer to
Figure 3.3.1. After choosing the RAID level, click “
”, it will be linked
to another page required to set up the “Bus ID” / “SCSI ID” / “LUN”.
Figure 3.3.1
Step 2: Please select a number for each of them. Be careful to avoid the conflict
of SCSI ID at the same SCSI bus. In this page, the “Volume size” can be
changed. The maximum volume size is shown. To re-enter the size be sure it
has to be less or equal to maximum volume size. Then click “
”.
Step 3: Confirm page. Click “
” if all setups are correct. Then a page
with the “User data volume” just been created will be shown as Figure 3.3.2.
Done. It can be used as a disk.
Enhance technology UltraStor RS16
- 16 -