User Manual

3
2.5 Battery level indicator
The battery level indicator consists of five segments. When the battery is fully charged, the five segments will be all on.
In case of undervoltage, the outline of the battery indicator will flash, which means the battery has to be charged
immediately.
Full battery level
indication
4-segment
indication
3-segment
indication
2-segment
indication
1-segment
indication
Undervoltage
flashing
Fig. 2-4 Battery Level Indicator Interface
2.6 Error code indicator
When a fault occurs in the electronic control system of your e-bike, the display will automatically indicate the error
code in the distance area in the format of E0**. Detailed definitions of error codes are shown in Schedule 1.
Fig. 2-5 Error Code Indicator Interface
■ When an error code appears on the display interface, please conduct troubleshooting in time. Otherwise, your
e-bike will not work normally.
3. General setting
■ All parameters can only be set when your e-bike stops.
The steps for general setting are as follows:
In the power-on state, when the display shows the speed of 0,
3.1 Trip distance reset
Press and hold the buttons
and at the same time for more than 2 seconds to reset the trip distance.
3.2 Factory reset
dEF refers to factory reset. dEF-n represents not to restore factory settings, and dEF-y represents to restore factory
settings. Press and hold the buttons and at the same time for more than 2 seconds to enter the factory reset
interface, and press the button / to select a parameter.
Fig. 3-1 Factory Reset Interface