Operator`s manual

The Lo and Hi Gain options generate different levels of noise, and I tuned the SM

Signature Amp's Noise Gate accordingly. However, there is some minor matching

variance between the two. stands to benefit most from the Noise Gate, so I

suggest that you tweak its two knobs for this mode.

Connect this FX Loop I output to a signal processor's input/return jack using the

shortest possible shielded cord equipped with 1/4" plugs. Activate and deactivate it via

the FX Loop I/II (16) button, which switches between these two loops. In the signal

path, is located post preamp and pre the two power amp Master knobs.

Connect this FX Loop I input to a signal processor's output/send jack using the shortest

possible shielded cord equipped with 1/4" plugs. Activate and deactivate it via the FX

Loop I/II (16) button, which switches between these two loops. In the signal path,

is located post preamp and pre the two power amp Master knobs.

FX mix control for . When the knob is set to , the amp signal is routed

through with no processed signal (0% wet balance) added to the mix. Twist the knob

clockwise to blend in the processed signal (parallel/passive, wet balance 1-99%,

depending on knob position). When the knob arrives at the Effect position, only the

wet signal (that is, the processed signal generated by the connected effect device) is

patched to the power amp (serial, 100% wet).

Set this knob to when this loop is not in use!

Connect this FX Loop II output to a signal processor's input/return jack using the

shortest possible shielded cord equipped with 1/4" plugs. Activate and deactivate it via

the FX Loop I/II (16) button, which switches between these two loops. In the signal

path, is located post preamp and pre the two power amp Master knobs.

Connect this FX Loop II input to a signal processor's output/send jack using the