Operator`s manual

5. :
, along with of that comes courtesy of
, a with Presence knobs for both Lead channels, as
well as for and enabling you to dial in
precisely the amount of high end you need ;.
6. further tone-tuning options such as an onboard featuring
for of the and a long Reverb
spring that conjures , as well as
that let you factor multi-effect processors into the sonic equation;
7. an that will give you years of
and .
-> : , , and with separate Gain
and Volume knobs, Clean and Crunch with a separate Treble control.
-> for the two Lead channels: let you active directly
two different gain settings for Lead I and Lead II, thereby extending the
number of potential Lead sounds to four.
> : one EQ for and
(main channel 1) and for and
(main channel 2). As a special feature, the Clean and Crunch channel
sports a dedicated Treble knob each.
-> for very natural-sounding reverb, with separate
knobs for the two main channels.
-> and are variable and switchable.
Each may be activated separately for every channel or one FX Loop may
be used as a hardware bypass.
four fundamental sounds in finest tube quality
total freedom tonal expression
Gain switching four-band EQ
two separate Treble knobs
to make your tone sparkle
reverb system
dedicated controls each two main channels
lush, deep and warm reverb two effect loops
ultra-advanced tone-generating machine
playing pleasure value to boot
Four basic channels
Two Gain options
Two dedicated and specially tuned voicing sections
Large spring reverb
Two effect loops:
Clean Crunch Lead I
Lead II
MIDI In Thru
, , and
a 4-band EQ with Presence control
-> , accessible via MIDI.
The amp can also be muted via MIDI controller 7.
-> for routing preamp or
power amp signals to mixers or recording gear, offering a precisely tuned
and very authentic-sounding speaker simulation.
-> and ports serve to integrate the amp into a MIDI system.
-> , accessible via 16 MIDI channels or OMNI.
-> The
The Serial Amp Control Port accepts the Custom Z-9 Footswitch (optional); use it
as a conventional switcher to select channels and two sound-shaping functions
directly. Then there's the MIDI In, which accepts the Z-9 for use as a simple MIDI
footcontroller or any other MIDI footcontroller. Finally, the amp is equipped with
a stereo jack that takes a dual footswitch, allowing you to switch the four
channels remotely.
-> for suppressing high-gain hiss in the Lead I and Lead II
channels.
-> the power amp section.
Clean Crunch
Clean Crunch Lead I Lead II
Hi Gain
Clean
Crunch Lead I
Lead II
FX Loop 1 FX Loop 2
Features and Functionality at a Glance
-
Balanced, frequency-compensated XLR line output
128 MIDI presets
Sovereign combo amp offers three different remote interface ports:
Noise Gates
Two fans for cooling
Two each power amp Master knobs
5