Operator`s manual

feedback. Avoid feedback squeals; they can lead to hearing loss and damage
speakers! At higher volumes, back off the Gain, Treble and Presence levels in order to
prevent unchecked feedback!
This is the preamp voicing section's passive low-frequency EQ for .
This is the preamp voicing section's passive midrange frequency EQ for .
This is the preamp voicing section's passive high-frequency EQ for .
Determines the level for . Use this knob to adjust the volume of and
dial in the desired balance in comparison with the other channels' levels. Because this
knob is located pre effects loop, it also determines the effects send level for .
TheyellowLEDtotherightoftheknoblightsuptoindicate ison.
Channel 2
Channel 2
Channel 2
Channel 2 Channel 2
Channel 2
Channel2
A tip from the designer:
12Volume2
9 Bass
10 Middle
11 Treble
13 CH 2
14 Presence
15 Depth Punch
To help you get acquainted with the amp's fundamental sounds, I recommend that
you set all tone controls to or slightly higher than the center or 12 o'clock position. For
higher-gain sounds in , your best bet is to turn the Treble knob down to
prevent the pickups and speakers from generating feedback (a setting in the 10-to -1
o'clock range is recommended).
Each channel is equipped with a dedicated EQ so you can tweak its sound separately to
suit your taste and the given sonic scenario. Bear in mind that you also have the Bright
(1) button, as well as the two power amp Presence (14) and Depth Punch (15) knobs,
at your disposal for shaping the frequency range. Though this passive voicing section's
controls range is narrower than that of a comparable active system, its EQ curve is
tweaked specifically for its designated purpose, and will give you satisfying results.
Press this button to activate preamp directly (in reciprocation with ,
, ). The yellow LED to the right of the Channel 2 Volume knob (12)
lights up to indicate is active. may also be activated via MIDI
program change, the ENGL Custom Z-9 Footswitch, or a dual footswitch.
Power amp Presence knob. This knob determines the power amp's high frequency
response.
This control shapes the lo frequency response in the power amp stage and affects all
channels.
Channel 2
Channel 2 Chanel 1
Channel 3 Channel 4
Channel 2 Channel 2
8