Operator`s manual

The Status LED above the Write/Copy (35) button indicates the following

conditions:

1. Memory error (possibly a defect in the EEPROM); Indication: LED flashes in five

short bursts; What to do: Press the Write/Copy button (this resets the LED, but

does not solve the problem).

2. No speaker connected; Indication: The LED flashes in a distinctive pattern,

illuminating briefly at regular intervals; What to do: Connect a speaker.

3. A programmable function's (or functions') setting(s) has (have) been edited;

Indication: LED flashes regularly; What to do: If desired, restore this MIDI preset's

original configuration (e.g. by selecting it again); the Status LED also extinguishes

once the new setting has been stored.

4. Copy process was activated by pressing the Write/Copy button;

Indication: LED lights up continuously; What to do: If desired, cancel the Copy

operation by changing the setting of a programmable feature; the Status LED also

extinguishes once the preset has been copied.

5. Power Tube Monitor: A problem or overload in power tube V1;

Indication: LED flashes in 1 short burst, followed by a longer pause, etc.;

What to do: Activate and deactivate ;

6. Power Tube Monitor: A problem or overload in power tube V2;

Indication: LED flashes in 2 short bursts;

What to do: Activate and deactivate ;

7. Power Tube Monitor: A problem or overload in power tube V3

Indication: LED flashes in 3 short bursts;

What to do: Activate and deactivate further information on page 28.

8. Power Tube Monitor: A problem or overload in power tube V4;

Indication: LED flashes in 4 short bursts;

What to do: Activate and deactivate ;

Standby

Standby;

Standby

further information on page 28.

9. Power Tube Monitor: A problem or overload in power tube V5

Indication: LED flashes in 5 short bursts;

What to do: Activate and deactivate ; further information on page 28.

10. Power Tube Monitor: A problem or overload in power tube V6

;

Indication: LED flashes in 6 short bursts; What to do:

Activate and deactivate Standby; further information on page 28.

Standby

(-> InVader 100 & 150);

(-> InVader 150);

(-> InVader 150)