Operator`s manual

shortest possible shielded cord equipped with 1/4" plugs. Activate and deactivate it via

the FX Loop I/II (16) button, which switches between these two loops. In the signal

path, is located post preamp and pre the two power amp Master knobs.

Connect this FX Loop II input to a signal processor's output/send jack using the

shortest possible shielded cord equipped with 1/4" plugs. Activate and deactivate it via

the FX Loop I/II (16) button, which switches between these two loops. In the signal

path, is located post preamp and pre the two power amp Master knobs.

FX mix control for . When the knob is set to , the amp signal is routed

through with no processed signal (0% wet balance) added to the mix. Twist the knob

clockwise to blend in the processed signal (parallel/passive, wet balance 1-99%,

depending on knob position). When the knob arrives at the Effect position, only the

wet signal (that is, the processed signal generated by the connected effect device) is

patched to the power amp (serial, 100% wet).

Set this knob to when this loop is not in use!

This is the InVader's preamp auxiliary out. It delivers a signal with almost the same level

and frequency response as the signal patched into the amp's input. A low-impedance

circuit, Pre Out is great for applications like addressing a guitar tuner. The Pre Out

signal is patched out to jack 55 even when Amp Mute is engaged. It can also serve as an

effect device send, whereby the amp's preamp (and EQ and gain stages) is bypassed.

This jack taps into the power amp circuit to retrieve its signal. The frequency response

of the Line Out's and the Power Amp Output's signals are identical (-> and they are not

frequency-compensated). Use it to do things like drive another linear power amp or

frequency compensation filter, say to simulate a 4/12 cabinet and feed this signal to a

recording system or PA.

4 ohms speaker output jacks, internal connected parallel. For diverse cabinet options

8 ohms speaker output jacks, internal connected parallel. For diverse cabinet options

16 ohms speaker output jack. For diverse cabinet options

FX Loop II

FX Loop II Dry

Dry

abinet options

abinet

options

53 FX Loop II Return

54 Balance

55 Pre Out

56 Line Out

57, 58 Poweramp Output, 4 Ohms Parallel

59, 60 Poweramp Output, 8 Ohms Parallel

61 Poweramp Output, 16 Ohms

NOTE:

IMPORTANT NOTE, please read and heed: Never operate the power amp without a

see the chapter on page 21

see the chapter

on page 21