User Manual

To select the channel ( ) and on the ENGL Special Edition
Amp E670:
-> Press twice; LED 3 above the button flashes;
Z-9 sends the corresponding S.A.C. command to .
To this end, must be configured accordingly in the
routine; that is, configuration may not be equal to *.
To select the channel ( ) and Master A on the ENGL Special
Edition Amp E670:
-> Press ; LED 2 above the button lights up.
Z-9 sends the corresponding S.A.C. command to .
To this end, must be configured accordingly in the
routine; that is, configuration is not equal to *.
To activate and on the Special Edition Amp E670
or the Preamp E570:
-> Press ; LED 5 above the button lights up;
Z-9 sends the corresponding S.A.C. command to .
To this end, must be configured accordingly in the
routine; that is, configuration is equal to *.
( ) on the Special Edition Amp or Preamp E570 activates:
-> Press ; LED 6 above the button lights up;
Z-9 sends the corresponding S.A.C. command to .
To this end, must be configured accordingly in the
routine; that is, configuration is equal to *.
* See on page 13 and 14 to learn what this designation means.
Serial Amp Control is a convenient remote control option for your ENGL amps. It
comes highly recommended if you do not work with a MIDI system or hands-free
selection ofchannels and controlof two sound-shapingor special functions of the amp
(for example, and via the two buttons) suffices for
your musical purposes.
If you want or need a greater range of remote control options for manipulating your
amp's sound-shaping and special functions on the fly, your best bet is to program the
desired settings for these functions to the 10 MIDI patches and access the presets in
MIDI mode.
-> Press and hold and simultaneously until LED 5 above the
button flashes.
If the button is programmed for A/B switching ( , "reciprocal
triggered" with the four channels) and the B function is currently active, LED 5
above the button will flash before you activate the routine. In this
event, switch to the A function first and watch the LED to ensure it indicates you
have activated .
-> Press the button to confirm the routine.
Lead I Channel 3 Master B
Channel button 3
S.A.C. Out
Function 1 Function 1
Setup Function 1's F1-1
Crunch Channel 2
Channel 2
S.A.C. Out
Function 1 Function 1
Setup Function 1's F1-1
Hi Gain Gain Boost
Function 1
S.A.C. Out
Function 1 Function 1
Setup Function 1's F1-6
Mega Lo Punch M.L.P.
Function 2
S.A.C. Out
Function 2 Function 2
Setup Function 2's F2-3
Comments
Hi Gain Mega Lo Punch Function
Channel 1 Function 1
Function 1
Function 1 F1-5
Function 1 Setup
Function 1 Setup
Function 1 Function 1 Setup
Note:
Note:
Note:
Note:
A tip from the designer:
2. Configuring the and buttons:
To assign a sound-shaping and special function to via the
routine:
Note:
Function 1 Function 2
Function 1 Function 1
Setup
9