User Manual

ManualsBrandsENGL ManualsFootswitch for AmplifiersZ9 Footswitch - FOOTSWICTH MIDI 5 BUTTONS

the activated channel and the activated function (say, and on

the E670 amp).

When you press this button in MIDI mode, it selects MIDI patch 5 in bank A and

in bank B. Pressing this button sends the given MPN to via MIDI

channel 1.

When you press this button in S.A.C. mode, it controls a previously programmed

sound-shaping or special function on an ENGL amp. LED 6 above the button lights up

to indicate the function is active. Assign the desired sound-shaping or special function

to in the routine. Access this configuration routine by

simultaneously pressing the and buttons until LED 6 above the

button flashes. Press the button to confirm your selection and to activate

the routine. Usingthe , , and

buttons, you can then select the amp's sound-shaping or special functions that you

want to remote control via the button. You have up to eight different

settings to choose from for : Each Channel button offers two different

sound-shaping or special functions; switch between the two options by pressing the

given Channel button twice. The LED assigned to this Channel button illuminates

continuously to signify one option, and flashes to signify the other. Immediately after

you have confirmed the , one of the LEDs above the Channel buttons

lights up or flashes to show the current configuration. To store a new assignment,

press andhold the button until the LED 5above the button lights

up. The Z-9 stores the given configuration (that is, your assignment of a sound-shaping

or special function on the amp to the button) in its nonvolatile memory so

that the setup is retained after you power it down. In case

button's switching action also reciprocates with the

, and buttons. Note that for this special

configuration ( set to other than in the

pressing the button a second time controls a special function on the amp (for

example, on the E670). The LED 6 above the button lights up to indicate

the currently active channel; a flashing LED 6 indicates the activated channel and the

activated function (say, and on the E670 amp).

In MIDI mode, this button selects Bank A or B. Press it to change banks. LED 6 above

this button as well as the LED above the button for the most recently activated MPN

flashes. Press a button to select the desired MIDI patch. LED 6 above the

button extinguishes to indicate or lights up to indicate .

contains MPN 1, MPN 2, MPN 3, MPN 4 and MPN 5; contains MPN 6, MPN 7,

MPN 8, MPN 9 and MPN 10.

Tube Driver Master B

MIDI

patch 10 MIDI Out

Function 2 Function 2 Setup

Channel 1 Function 2

Function 2

Function 2Setup Channel 1 Channel 2 Channel 3 Channel 4

Function 2

Function 2 Setup

Function 1 Function 1

Function 2

Channel 1 Channel 2, Channel 3 Channel 4

Function 2 F1-1 Function

1 Setup)

Master A/B

Tube Driver MasterB

MIDI Patch

Bank A/B Bank A Bank B Bank

A Bank B

Patch 5/10

Function 2

or button

Bank A/B

Function 2

F2-5, Function 2

F2-5 Function 1

is programmed

to configuration

and set