User Manual
LED 5 above the button lights up and the amp function(s)
currently assigned to this button is/are activated. If the button is
programmed for A/B switching ( , "reciprocal triggered" with the
four channels ), the amp will switch to the corresponding channel (for example,
or ). One of the LEDs 1 to 4 located above the
to buttons will light up or flash to indicate the amp's
sound- shaping or special function that is currently assigned to the Z-9's
button.
Here's how to select the desired sound-shaping or special function on your amp via
the Z-9's using one of the four , , and
buttons: Press the appropriate button once or twice for the given
configuration. The table on page 13 lists the assignments of sound-shaping and
special functions to .
Say you want to control the sound-shaping functions
(S.A.C. command ) on the Special Edition Amp E670 or Preamp
E570. Note that for purposes of this example, the sound-shaping functions
and (via the common S.A.C. command ) are currently
assigned to .
-> Press and hold and simultaneously until the LED 5
above the button flashes.
-> Press the button to confirm the routine.
LED 5 above the button lights up and LED 2 above
the button flashes to indicate the current configuration .
-> Press once or twice until LED 2 lights up to indicate
the new configuration, which is .
-> Store it by pressing and holding the button until LED 6
lights up once briefly.
-> Press and hold and simultaneously until LED 6
above the button flashes.
If the button is programmed for A/B switching ( , "reciprocal
triggered" with the four channels and configurations other than )
and the B function is currently active, LED 6 above the button will flash before you
activate the Function 2 Setup routine. In this event, switch to the A function first
and watch the LED to ensure it indicates you have activated .
-> Press the button to confirm the routine.
LED 6 above the button lights up and the amp function(s)
currently assigned to this button is/are activated. If the button is
programmed for A/B switching ( , means "reciprocal triggered" with the four
channel buttons ), the amp will switch to the corresponding channel (for
example, on the E670). One of the LEDs above the to
buttons will light up or flash to indicate the amp's sound-shaping or
special function that is currently assigned to the Z-9's button.
Here's how to select the desired sound-shaping or special function on your amp via
the Z-9's Function 2 using one of the four , , or
Function 1
Function 1
F1-5
Tube Driver Preamp Defeat
Channel 1 Channel 4
Function 1
Function 1 Channel 1 Channel 2 Channel 3
Channel 4
Function 1
Function 1
Modern/Classic F1-2
Gain Boost Hi Gain F1-6
Function 1
Channel 1 Function 1
Function 1
Function 1 Function 1 Setup
Function 1
Channel 2 F1-6
Channel 2
Function 1 F1-2
Function 2
Channel 1 Function 2
Function 2
Function 2 F2-5
Function 1 F1-1
Function 2 Setup
Function 2 Function 2 Setup
Function 2
Function 1
F2-5
Tube Driver EQ Channel 1
Channel 4
Function 2
Channel 1 Channel 2 Channel 3
Example:
To assign a sound-shaping and special function to via the F
routine:
Note:
Function 2 unction 2
Setup
10