Tube Amp Powerball Full Tube Guitar Amplifier Operator´s Manual Please, first read this manual carefully!
A four-channel, all-tube powered head, the Powerball offers sound-shaping options unrivalled by any other amp. Designed to satisfy the exacting demands of discerning players, it delivers all the tonal hues and colors you need to paint the most vivid musical pictures imaginable. Housed inside this newly designed enclosure is a powerhouse 100-watt amp boasting 6L6GC tubes.
5 Bass Bottom end voicing control of the preamps´s passive EQ for Main Channel I, Clean und Crunch. 6 Middle Mid-range voicing control of the preamps´s passive EQ for Main Channel I, Clean und Crunch. 7 Treble-Clean Upper range voicing control of the preamps´s passive EQ for Main Channel I, Clean mode. 8 Treble-Crunch Upper range voicing control of the preamps´s passive EQ for Main Channel I, Crunch mode.
21 Middle open Mid-range voicing control of the preamps´s passive EQ for Main Channel II, Lo and Hi Lead. This control determines the response of a specific mid frequency range when sound style "open" is selected. 22 Middle focused Mid-range voicing control of the preamps´s passive EQ for Main Channel II, Lo and Hi Lead. This control determines the response of a specific mid frequency range when sound style "focused" is selected.
Rear Panel REPLACE FUSE ONLY WITH SAME TYPE AND RATING ! CAUTION ! Footswitch Custom Footswitch Port Noise Gate ! DO NOT OPEN ! RISK OF ELECTRIC SHOCK ! DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE ! F.X.
REPLACE FUSE ONLY WITH SAME TYPE AND RATING ! ! CAUTION ! Footswitch Custom Footswitch Port Noise Gate DO NOT OPEN ! RISK OF ELECTRIC SHOCK ! DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE ! F.X.Loop Lead Channel R Poweramp Output 100 W All-tube Guitar Head Amp Powerball TYPE E645 designed by Horst Langer MADE IN GERMANY Master Style 1. or Channel Gain CAUTION ! Connect To Custom Footswitch Z-5 Only ! 4 Off-Lo Hi Send Return 2.
Sound setting samples: Ch I Gain Bass Middle Treble-Clean Treble-Crunch Clean Volume Crunch Volume Presence Depth Punch Powerball Bright Bottom Tube V1 V2 V3 V4 R Power Tube Monitor Amp Input Ch II Gain Bass Mid-open Mid-focused Treble Lo Lead Vol. Hi Lead Vol.
Handling and Care Protect the amp from mechanical knocks (tubes!). Let the amp cool down before you transport it (approx. 10 minutes). Tubes need about 20 seconds to warm up after you switch the power on, and further few minutes before they reach their full power capability. Avoid storing the amp in damp or dusty rooms, they are hard on jacks, switches and potentiometers. Make sure air can circulate at the front and top of the amp to allow for adequate cooling (increases component life).
