User Manual

12. Selecting MIDI channels.

Activate this selection routine while the preamp is in Manual mode.

Note:

You must select the bank to which you want to assign a MIDI channel before you

activate MIDI Channel Select mode.

Press the two buttons simultaneously. The preamp switches to MIDI Channel

Select mode. After about two 2 seconds the display will indicate the assigned

MIDI channel. In this example it is channel 01.

<->

Press the DOWN button twice. Normally you will scroll to the next lower MIDI

channel number every time you press the button, but in this case the display will

scroll from channel 01 to Off and then to OMNI mode.

MANUAL

ODE

<->

WRITE

OPY

Now you can store the desired MIDI channel, which in this example is actually all

of them or OMNI. Press and hold the WRITE button until the display stops flashing

and Manual is indicated statically.

Otherwise, the programming procedure will be canceled.

RITE

OPY

after approx.

2 seconds

OWN

<=>

Note:

To distinguish between the presets of the two banks when you want to access

both banks, these banks must be assigned to different MIDI channels. This means

that you can't assign the same MIDI channel to both banks. If you select a MIDI

channel that has already been assigned to the other bank, the display will let you

know that this is the case—this channel number will begin flashing.

If you set a bank to OMNI, you can't assign a channel to the other bank. Your

only option is to set MIDI channel reception to OFF.

Note:

You can activate MIDI Channel Select mode to simply check the given MIDI

channel assignment and press the MANUAL button to quit this mode without

storing a new MIDI channel.

The system quits this routine automatically after about 12 seconds.

<->