User Manual

6. Copying settings from a factory preset

to a MIDI preset.

For purposes of this example, the preamp is in Manual mode.

Select the desired factory preset as the source for the Copy operation. In this

example it is factory preset CA9.

You can change the sound-shaping settings of a factory preset before you copy it.

The preamp will always copy the last settings you dialed in for a factory preset

before you pressed the Copy button.

Hold the button down until the display stops flashing and preset 5 lights up

continuously. The settings of factory preset CA9 were dumped to MIDI preset 5.

Note:

The original settings of this MIDI preset are automatically dumped to shadow

preset 5. You can load them back to the MIDI preset at any time.

Heads Up:

You can't use a locked preset as the target of a copy operation!

Reminder:

You can press the MANUAL button at any time when you want to cancel the

operation and quit Copy mode.

Press the button briefly. The Copy option is active for about 30 seconds.

The system will quit Copy mode automatically if you don't select a new preset

during this time.

The center decimal point in the display appears to indicate Copy has been

activated.

<->

RITE

OPY

after approx.

30 seconds

RITE

OPY

<=> =>

Select MIDI preset 5, bank A as your target preset immediately after you activate

Copy.

DOWN