User Manual
19
45 MIDI IN
This 5-pin DIN port is designed to accept data sent by a MIDI sender (for example,
the ENGL MIDI foot controller Z-12) or data sent from or routed through another
MIDI device.
Switch no. 46 lets you activate the preamp's power supply if you have an ENGL
MIDI foot controller connected to this port.
CAUTION: Before you connect any other MIDI footswitches or MIDI effect
devices, always make sure that switch no. 46 is set to the right to avoid damaging
any gear you have connected.
46 On-board Selector Switch for the MIDI IN Port
This switch activates a power supply for the ENGL MIDI foot controller. Power is
fed to the board via the MIDI circuit. When the switch is set to the left position
(ENGL MIDI Footcontroller), the preamp's power supply is routed to pin 1 and pin
2 of the MIDI IN port.
Whenever you use any other MIDI foot board, be sure to set the switch to the
right to avoid damaging it. If the foot board you are using is equipped to handle
phantom power, consult its operating manual to find out to how it is wired
(which pins carry its power supply) and what its voltage and current specifications
are.
If the voltage and current specifications and wiring match, you may set the switch
to the left to supply this foot board with power over the MIDI cord.
Read and heed: Be aware that any MIDI foot board you intend to supply with
power via this port may not draw or consume more than 200 milliamperes of
current. You must also find out if the MIDI foot board is able to handle 11 volts of
alternating current (AC)! If you are in any doubt, be sure to consult a specialist,
meaning an amp technician or electronics engineer who earns a living with a
screwdriver!
-> DOWN 015, etc.
-> DOWN 016: MIDI channel 16.
-> DOWN onI: OMNI mode, MIDI commands are received on
all MIDI channels.
off: all MIDI channels off, MIDI commands are
not received by any MIDI channel.
-> UP 01: MIDI channel 01.
-> UP 02: MIDI channel 02.
-> UP 03, etc.
Preset and MIDI Channel Array
In this section, we'll take a look at the sequence in which you can dial up presets
using the UP and DOWN buttons on the face of the preamp or the software
Remote Control Panel on a PC.
Note that you can only call up the 128 presets of bank A and B via MIDI
commands. The following list points out the sequence of MIDI presets starting
with Manual 000.
You can only access and adjust MIDI channels on the actual preamp in MIDI
Channel Select mode, but not via the Remote Control Panel.
MIDI channels: